The line is the special pultrusion machine used to produce FRP rebar with different specifications. It can finish distributing roving, impregnation, pre-molding, winding, heating and curing, unwinding, fix-length cutting and pile up automatically.
FRP rebar machine is made by fiberglass yarn racks, resin tanks and pre-formation, winding equipment, temperature control system, traction equipment, auto-cutting, resin recycling, and control cabinet.
1) Fiberglass yarn rocks
It is used fro set the fiberglass yarn and control the way of yarn, keep the yarn tie a knot, make the manufacture goes well.
2) Resin tanks and pre-formation:
They can make the fiberglass yarn have a totally impregnation and control the way of the yarn's working, making a preformation for the products.
3) The winding machine can control the distance and depth of screw, it drived by two 1.5kw motors.
4) The temperature control system can use control the heat temperature, make the rebar have totally solidify, with 28kw power.
5) The traction equipment can pull our product in a special temperature, with a 5.5kw power motor.
6) The auto cutting equipment can cut into short length based on the needs. with a 1.2kw power motor.
7) The control cabinet is monitor to the total running of the rebar/rock bolts machine.
1. Technical parameter
|Working voltage: 380V/50Hz|
|Total power: ≈30KW|
|Air pressure: 0.4-0.6Mpa|
|Center height of the line: 1000mm|
1)four anchor rod machine rated total power 25KW. The four anchor is the other company, a rock forming machine (a bolt forming machine rated power 32KW) 0.78 times.
2) high production efficiency, 4000-6000 meters per day. Production efficiency is 3 times more than other companies a rock bolt.
3) energy saving, power consumption per meter is only 0.06 degrees. Energy efficiency is 3 times more than other companies a rock bolt.
4)the quality of the products; any phthalate unsaturated polyester resin and roving products meet the requirements of MT/T1061-2008. In particular, the yarn is full of yarn.
5)35 mm diameter specifications for the production of 8 mm. Cutting length.
1)bolt machine can produce four same diameter, with the same pitch, with the same length of the whole screw thread glass.
2) high efficiency;
Production of about 3.2 meters per minute, more than 4000 meters per day. 6000 mm diameter of the following 12 meters per day can be produced.
3) energy saving
Power consumption per hour is less than 11 degrees. The power consumption is less than 0.07 meters per anchor, at the same time due to multiple production equipment. The device adopts double layer heat insulation closed oven, which greatly improves the utilization of energy.
4)low cost, high efficiency, saving raw materials, low production cost, operation and maintenance;
5) advanced molding technology, molding process, tooling;